Before updating your Sunlu T3 firmware, make sure to:
| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | | Wrong screen firmware or bad SD card | Reformat SD (4096 bytes). Re-download the DWIN_SET . Use a different brand of SD card (Sandisk works best). | | Printer beeps continuously | Mainboard firmware name is wrong | Rename file exactly to firmware.bin . Ensure it is the correct file for your motherboard chip (STM32F103 vs F407). | | Touch screen says "No printer attached" | Mainboard and screen firmware versions are mismatched | Flash the mainboard again. Then flash the screen. Version numbers must align (e.g., both v2.5.3). | | Printer freezes on boot logo | Corrupted bootloader | You need to use an ST-Link programmer to force flash the bootloader (advanced). Or contact Sunlu support for a replacement motherboard. | | Thermal Runaway error on first heat | PID values are wrong | Let the printer cool. Run the PID tuning command immediately. Do not try to print until PID is saved. | Sunlu T3 Firmware Update
The screen runs its own independent processor. It requires a separate update. Before updating your Sunlu T3 firmware, make sure
immediately after updating to ensure old settings don't conflict with new firmware. | | Printer beeps continuously | Mainboard firmware